Librarium Online Forums banner

Combi-Flamers

934 views 8 replies 8 participants last post by  Tubal 
#1 ·
Anyone have any tips on converting Combi-flamers? I have plenty of flamers from my catachan sets, and a couple of bolters. Any suggestions?
 
#4 ·
Just glue the flamer nozel to the top of the bolter and the canister underneath the muzzle.
 
#5 ·
On the Vet sarg sprue there is a hand flamer, just trim it down, then remove and reverse the bolter magazine and glue the hand flamer on, takes like 2 min to complete.
 
#9 ·
I'd convert it from a storm-bolter, you already have two barrels then. Trim off one of the barrels (or both if you have tubing to replace it with) and put a flamer-nozzle nex to it. Glue a fuel tank either on the bolter itself (looks unwieldy) or use guitar wire to link it to the backpack or a tank in his belt or whatever you think looks good.

And no, there is no combi-flamer in the commander box, but the combi-melta is probably convertable.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top